Diode-led K-RANGE 24 Wall Mount Controller Bedienungsanleitung Seite 2

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 1
INSTALLATION GUIDE
K-RANGE 24™ WALL MOUNT CONTROLLER
2 of 2
IG022614-1.0
Fixture does not illuminate
Ensure the system is wired correctly.
Verify polaries are correct.
Ensure a compable constant voltage dimmable xture is installed.
Ensure a compable constant voltage driver is installed.
Ensure the driver and xture have the same voltage specicaons (12V & 12V, or 24V & 24V).
Fixture is ashing or ickering
Verify a compable constant voltage driver is installed.
Ensure a compable constant voltage dimmable xture is installed.
Ensure all connecons are properly secured.
Ensure no more than a single controller is aached to each driver output.
Fixture is slowly ashing
Ensure driver is not overloaded. An overloaded driver will cause the internal auto-reset of the driver
to trip repeatedly.
Correct colors are not illuminang
Verify the correct leads are connected to the correct terminals on the receiver. Some tape light MFG
labeling varies. Swap WW and CW leads if necessary.
Ensure potenal leads at opposing end of xture are not crossed.
Touchpad does not respond Ensure the ribbon cable inside the faceplate is properly secured.
Operation
Mounting & Wiring Connections
Troubleshooting
Prior to troubleshoong, ensure a compable system is installed. Verify compable xtures, drivers, controls and addional components were specied
correctly. For addional quesons/concerns, contact technical support. Please have all part numbers on hand for fast and ecient technical assistance.
From 12-24VDC
LED Driver
To 12-24VDC
LED Load
V− (from driver)
V+ (from driver)
Extra wire (cap off)
WW (to fixture)
V+ (to fixture)
CW (to fixture)
Pop off faceplate with a flathead screwdriver.
Kelvin Adjustment
Adjust Kelvin (color temperature)
Decrease Brightness
Decrease brightness (80 levels)
Increase Brightness
Increase brightness (80 levels)
Power/Sound
Turn controller On/Off. Hold for
3 seconds to turn sound On/Off.
WW
CW
V+
V+
V−
From 12-24VDC
LED Driver
To 12-24VDC
LED Load
Determine the number of low voltage outputs of the driver when installing mulple PWM controllers. No more than one PWM controller can be aached to
a single output of the driver.
Seitenansicht 1
1 2

Kommentare zu diesen Handbüchern

Keine Kommentare